Page 214 - Electronic Mechanic - TP - Volume - 2

ELECTRONICS MECHANIC - CITS

2 Cleaning Solution: To make a cleaning solution, use a mild dish soap and water. Avoid applying powerful
chemicals that could damage or contaminate the water source.

3 Scrub and Rinse: Scrub the interior of the reservoir with the cleaning solution using a soft brush or sponge.
Give special attention to corners and gaps where dirt can collect. To remove soap residue, carefully rinse with
clean water.

4 Airing Out: After rinsing, allow the tank of air to completely dry. This prevents germs and microbes from
growing in a moist environment.
5 Restore and test: Once the reservoir has been dried, rebuild it according to the manufacturer’s instructions.
Make sure that all components are securely attached. Connect the purifier and test its operation to ensure
there are no leaks or problems.

Clean the Filters of Water Purifier
The filters of a water purifier should be cleaned regularly to remove dirt, dust, and bacteria to ensure the on-going
supply of clean and safe drinking water.

1 Turn Off and Disassemble: Turn off the purifier’s water supply. Carefully remove the filters from their places,
following the manufacturer’s instructions.
2 Rinse Pre-Filter: Pre-filters should be carefully rinsed under running water to get rid of dirt and waste. This
prevents blockage and keeps the water running.
3 Prepare Cleaning Solution: Make a cleaning solution with water of white vinegar or citric acid. These natural
compounds help in the removal of mineral accumulation and the disinfection of the filters.

197
CITS : E & H - Electronics Mechanic - Exercise 173