Page 265 - Electronic Mechanic - TP - Volume - 2

ELECTRONICS MECHANIC - CITS

EXERCISE 187: Perepare data tables and monitor

Objectives
At the end of this exercise you shall be able to
• to create simple ladder logic program using software
• to demonstrate table creation from the software
• to demonstrate use of monitor command in PLC.

Requirements

Tools/ Materials
• Power Supply - 1 No. • PC/LAPTOP Latest configuration - 1 No.
• Wiring Materials and connectors - 1 No. • PLC for Programming - 1 No.
• Communication Ports and cables - 1 No.

Procedure

Theory

Note: Most newer PLCs having its own configuration methods.Advised to follow respective user
manual.(Most of the procedures are same), Considered Siemens PLC as an example.
Setting up your S7-1200 PLC using STEP 7 Basic

Configure your S7-1200 PLC and provide data to be monitored via an Open Platform Communications (OPC)
connection.
Create a program in Main [OB1]
In the “Program blocks” folder of your PLC, double-click the “Main [OB1]” instruction. Copy the program shown
in the next picture.
You will find the bit logic operations in the “Bit logic” folder in the “Instructions” pane on the “Instructions” task card.
Drag’n’Drop the “Normally open contacts”, “the Output coil”, and the “Set/Reset flip-flop” into “Network 1” of your
“Main [OB1]” work area, according to the picture shown below. Make sure that the input fields are configured in
the same way as shown in the Fig 1.

Fig 1

248