Page 172 - CITS - Welder - Trade Practical

WELDER - CITS

EXERCISE 38 : Pipe butt weld butt joint on MS pipe
25mm o.d. 3mm w.t. position 2G vertical
arc welding

Objectives

At the end of this exercise you shall be able to
• cut bevel the pipe for welding
• tack pipes for butt welding
• make root run by rotation method
• make filling run by rotation
• clean the job and inspect for defects.

Job Sequence

• Cut the pipes to the given size.

• File pipe ends to be at right angle to the pipe axis.
• Grind the edges to 30° to 35” bevel maintaining 1.5 to 1.75mm root face.
• Remove the burrs and rust from the pipe ends.
• Check the perpendicularly of the work piece using the try square.

• Arrange the 2 pipes to form as a butt joint.
• Use a fixture or V profile of an angle iron to align pipes in 6G position.
Note: Wear protective clothing (safety apparels)

• Switch on the machine and select a 3.15mm dia electrode for tacking and the root run and set 100 amps
current.
• Put4 tacks at regular intervals adjusting 2mm root gap between the pipes using spacers.

• Ensure that each tack ends with a keyhole.
• Check and ensure that the pipes are in line after tacking.
• Set 110amps for a 3.15mm dia electrode for root run.
• Deposit the root run in flat position by rotating the pipe.

• Welding using the keyhole technique ensures root penetration.
• Remove slag from the root thoroughly.
• Deposit the second and third run using 3.15mm dia electrodes i.e. the same ad for the root run.
• Clean and inspect the joint.
a To ensure uniform and correct reinforcement

b To ensure that the weld face is free from porosity, slag inclusion, unfilled crater, overlap and edge of plate
melted off/insufficient throat thickness

155