Page 331 - CITS - Welder - Trade Practical
P. 331

WELDER - CITS



           EXERCISE 97 :  Analyze & Prepare welding inspection

                                        reports


            Objectives

            At the end of this exercise, you will be able to
            •  check all documentation
            •   check all consumables
            •  check materials, dimensions, and condition
            •  preheating, method, and temperature
            •  check fit and set-up
            •  ensure no undue stress is applied to the joint
            •  check welding equipment
            •  check amperage, voltage, polarity.





































           Job Sequence

           -  Welding symbols and weld sizes clearly specified in drawing and related documents.
           -  Weld joint designs and dimensions clearly specified in drawings and related documents.

           -  Weld maps identify the welding procedure specification (WPS) to be used for specific weld joints.
           -  Dimensions detailed and potential for distortion addressed.
           -  Welding consumables specified.
           -  Proper handling of consumables, if any, identified.

           -  Base material requirements specified (such as the use of impact tested materials where notch ductility is a
              requirement in low temperature service).




                                                           314

                                                                                                                                                                  CITS : CG & M - Welder - Exercise 97
   326   327   328   329   330   331   332   333   334