Page 19 - Electronic Mechanic - TP - Volume - 2

ELECTRONICS MECHANIC - CITS

Fig 3 Fig 4

5 Continue to hold the display panel with one hand, and use your other hand and a spudger to disconnect the
black ribbon cable labeled “1”.(Fig 5)
6 Rotate the display assembly up until it is roughly vertical. This will allow easier access for removing the
remaining cables. (Fig 6)

Fig 5 Fig 6

7 Use a spudger to disconnect the black ribbon cable labeled “2”(Fig 7)

8 Use a spudger to flip up the white plastictab holding the remaining cable in place. The white tab will rotate up
90 degrees, releasing the ribbon cable(Fig 8)

Fig 7 Fig 8

9 Slide the black ribbon cable out of its connector, and remove the display assembly from the cell phone.(Fig 9)

10 Remove the screws surrounding the motherboard:
Remove the screws 2-3 mm star screws with partial thread securing the logic board to the rear panel. (Fig 10)

2
CITS : E & H - Electronics Mechanic - Exercise 118