Page 235 - CITS - Fashion Design Technology - Trade Practical
P. 235

FASHION DESIGN & TECHNOLOGY - CITS




           1  First trace the sleeve block pattern and mark the center between the cap and biceps. Square a line across the
              sleeve cap from this mark. Mark 1/2 inch down from the center grainline, and draw a curved styleline and mark
              the point  T. Measure armhole curves P to T and Q to T and note it. Separate cap from lower sleeve. Please
              refer the shaded area. Cut through grainline to separate the cap as shown in the following figures.



















           2  Trace patterns, allowing room for the sleeve cap. Trace back bodice, transferring shoulder dart to armhole.
              Trace front bodice. Please note that R to T= P to T  and S to T  =  Q to T.























           3  Place the cap sections on front and back bodice, with T-points touching and curve of the cap 1/4 inch away
              from the shoulder tips.  Now, Mark 1/4 inch up from the shoulder tips and draw, blending curve over the cap
              and ending at mid-shoulder, as shown. When trueing, blend the curve of the shoulders.
           4  Finally, in Bodice, mark 1/2 inch to the cap and draw a blending line to the shoulder tip and completes the
              pattern.





























                                                           220

                                CITS : Apparel - Fashion Design & Technology - Exercise 15                                                             CITS : Apparel - Fashion Design & Technology - Exercise 15
   230   231   232   233   234   235   236   237   238   239   240