Page 156 - CITS - Fashion Design Technology - Trade Theory
P. 156

FASHION DESIGN & TECHNOLOGY - CITS




           Draw lines from D and E to A.
           Divide into fourths. Square out and mark measurements given. Use curve rule touching each point.
           Hemline: See Figure 7 for cuff length. Add to the measurement two 1 1/4” pleats (2 1/2”)

           and square out equally from B to F and to G.
           Draw lines from F to D, and G to E.
           Slit placement: Half the distance from B to G,
           less 1/2”. Slit length is 5 1/2”. See (Fig 6 b).
           Walk the sleeve to armhole, and mark notches: 1 notch front and 2 notches in back. (Ease allowance about 1/2
           inch. Adjust

             Fig 6a                                               Fig 6b






















           Cuff
           Measure hand for entry measurement and add 1/2”,
           or choose a size from the following.
           Small 9”, Medium 9-1/2”, Large10.
           Cuff includes 1” extension for button placement.Fig 7

           Width of cuff 2 1/2”. See example (b). (Fig 7a, 7b)
             Fig 7a                                  Fig 7b











           Collar and Stand
           Draw a rectangle 1-3/8” wide and length of the neck-line measurement, A to B, plus 3/4”. Mark C. Square up from
           C. Mark shoulder notch, D.
           Mark 1/2” up at C. Draw curve lines from C to B end end at D to complete collar stand. Cut from paper.
           Collar: Trace collar stand. Draw collar shape, using

           measurement given (b).
           Cut collar, slash and spread, as shown (c). Trace and cut two copies and interfacing. Repeat for collar stand.
           (Fig. 8 a, b, c)



                                                           143

                                CITS : Apparel - Fashion Design & Technology -Lesson 13-24
   151   152   153   154   155   156   157   158   159   160   161