Page 13 - CITS - Fitter Trade Practical - Volume -2
P. 13
CONTENT
Ex. No. Table of Contents Page No.
Module 6
58 Single riveted lap joint 1
59 Checking the thickness of the sheet metal and the diameter of the wire using
standard wire gauge (SWG) 3
60 Shop floor demonstration practices as many as possible on different gauges 15
61 Checking the different gauges by using radius, wire, snap, plug, ring etc. with
an accuracy of ± 0.02mm and their heat treatment practice and hardness
testing by different methods 16
Module 7
62 Mark off and drill through holes 25
63 Drill through and blind holes at an angle using swivel table of drilling 43
64 Layout the spacing for rivet holes to make a single riveted lap joint 46
65 Dismantling and mounting of pulleys 56
66 Make a simple drilling jig 62
67 Making of template / gauge to check involute profile 74
68 Prepararion of simple press tool & try out of component 77
Module 8
69 Demonstration on broaching machine operation bu audio & visual aids 90
70 Revision and internal assesment 91
71 & 72 Make male & female open fitting with an accuracy ± 0.05mm 92
73 Repair & replacement of belts and check for workability 95
74 Demo on surface finishing measurement 99
Module 9
75 Demonstration on Sine bar and its applications 100
76 Demonstration on Dial test indicator and its uses 101
77 Slip Gauges 102
78 Demonstration on Digital calipers on workshop 111
79 Demonstration on digital micrometers and its applications of workshop 112
80 & 81 Checking of angles with angle gauge and bevel protractor 113
82 Revision & Internal Assessment or Digital measuring Instrument 116
83 & 84 Co-ordinate Measuring Machine (CMM) 117
Module 10
85 Practicing and Inspection of dismantling &assembly of different Valves, stop
cocks, bearing, pullers, etc., and checking for Leakage 126
x
