Page 29 - CTS - Mechanic Diesel - TP

MECHANIC DIESEL - CITS

Select the distance piece in such a way that while pressing the shaft/bush, it does not touch the body (minimum
10mm gap to be given between the plunger (6) and the distance piece)
Place the distance piece on the shaft/bush. Ensure that it does not touch the body.
Operate the low pressure lever (7) and make the plunger (6) to have a contact on the job,

Operate the heavy pressure lever (8), observe the load on the gauge(9) and the job simultaneously. Ensure the
job comes out gradually.
If the load exceeds more than the specified limit, stop the pressing.

Safety
1 Shield brittle parts such as bearings to prevent flying of parts.
2 After finishing the work loosen the plunger releasing knob (2).
3 Remove the job and clean.

Two post car hoist
Park the vehicle in the centre of the electro mechanical hoist.
Adjust and fix the telescopic two post lift lifting arm.
Use the automatic arms locking and releasing device while lifting and lowering.

Set safety mechanism to prevent uneven lifting.
Use the extra safety nut.
Check the chain drive and operate the lifting switch.
Use the anchoring bolts for safety (Fig 9).

Four post lift
Drive the vehicle on the leveled ramp of the four post lift.
Check the vehicle parked correctly are not on the romp & use wooden block as a stopper
Check the vehicle door and glasses are closed & pull up hand brake lever of vehicle.
Drive the hydraulic cylinder in stable & lowering.

Offering pull range mechanical protection by using safety block
Connected by using steel cables, Forced synchronized movement of the lift in order to effectively prevent the
sloping of the vehicle

Ton with extended run way length for LCV and Bigger vehicle.

Fig 9 Fig 10

12

CITS : Automotive - Mechanic Diesel - Exercise 1.3