Page 242 - CTS - Sewing Technology - TP - Volume - 2-0

SEWING TECHNOLOGY - CITS

Fig 2

To stop the knife descend knife latch
Thread breakage occurs after sewing due to some other reasons, keep on pressing down knife stop lever lightly
until the machine stops then the knife will not cut the fabric. (Fig 3)

Fig 3

Attach speed gear to the shafts

1 Push gear into the shaft so that it is securely fixed by the pin on gear bushing.
2 Located to an open
3 For installing gear on the pin rear gear bushing.
4 Push gear into the shaft while turning it the arrow direction. (Fig 4)

Fig 4

Adjust the length of the button hole
1 Pull out the cover
2 Raise the cover
3 Loosen the nut by using spanner

4 Set the point to a desired length on scale. Then tighten the nut. Then through the trial sewing adjust the length
of button hole as per requirement. (Fig 5)

227

CITS : Apparel - Sewing Technology - Exercise 36 CITS : Apparel - Sewing Technology - Exercise 36