Page 113 - CITS - Dress Making - TT - 2024

DRESS MAKING - CITS

Trace and trim: (Control + Shift + T)
- It traces the line and Trims the line

- First Select the Trace & Trim tool
- Then Select the line to be Traced & Trimed
- Select the point to be trace then select the Perimeter line upto be extended.
The line gets extended.
lines between segments :

- First Create a new piece of different measurement
- E.g. Length – 27.95 cm - Width – 14.23 cm
- Then if you want Horizontal line, Select the points 1,2,3,4
- Then give OK.

- If you want Vertical lines, Select the points 4,1,2,3

Hole overcut
- First put an internal circle, Using Circle Tool

- Use circle to Contour Tool and Put No. of Points in the cirle.
- Then use Hole Overcut Tool
- Select a point on closed internal for hole overcut.
Used while cutting for cutting circles to reduce confusion (i.e) Where to start, Where to stop.

Piece tools
Walk (W) :
- Used to check the circumference of Sleeve and Circumference of Armhole
First Join the front & back part of the bodice at the shoulder point and keep the sleeve part ready.
- Select a point on the moving piece

- Select a point on the stationary piece
- F11 to Flip the Piece
- Now Check the Measure
- The measurement of the sleeve crown should match to the measurement of the armhole.
Walk segment (Shift + Alt + W)

Measure (Ctrl + D) :
X = 20.8 (Horizontal)
Y = 4.76 (Vertical)
Angle = 14 o (Angle)
Distance = 21.4 (Diagonal of line)

Segment Length = 31.1
Select the first point then select the second point.

98

CITS : Apparel - Dress Making - Lesson 8 & 9