Page 158 - CITS - ED - Mechanical
P. 158

ENGINEERING DRAWING - CITS



           •  Draw the shank with short break.

           •  Draw firm lines of the edges of the rivet.
           •  Show the dimensions in terms of dia of shank. (Fig 1)

           Exercise 8.26
           Pan head rivet
           Draw a pan head rivet of shank diameter 30 mm. (Fig 2)
           •  Follow the procedure of Ex.15.25



              Fig 2

















           Exercise 8.27
           Conical head rivet
           Draw a conical head rivet of shows diameter 25 mm. (Fig 3)
           •  Draw a horizontal thin line.
           •  Draw a vertical centre line.
           •  Mark the diameter of rivet head and shank as per proportion.
           •  Set off 0.8d on the centre line as shown in Fig 3 from the horizontal line.
           •  0.25d as radius, draw an arc as shown in Fig 3.
           •  1.5d as radius, draw another arc, tangential to the previous arc of radius 0.25d.
           •  Draw the firm lines of the edges of the rivet.
           •  Show the dimensions in terms of diameter of shank.

              Fig 3

















           Exercise 8.28
           Countersunk head rivet

           Draw a countersunk head rivet of shank diameter 25 mm.
           •  Draw a horizontal line.


                                                           145
                                     CITS :Engineering Drawing (Mechanical) - Exercise 8
   153   154   155   156   157   158   159   160   161   162   163