Page 173 - Electronic Mechanic - TP - Volume - 2

ELECTRONICS MECHANIC - CITS

3 Remove the air cover.

High Voltage
Transformer
4 Replace the High Voltage
Transformer
5 After replace, reconnect the
Leads correctly and firmly.
6 Replaced High voltage
transformer carefully.

3 Oven is not getting proper power in the circuit
Replacement of Fuse
1 Disconnect the oven from the power source.
2 When12A fuse blows out by the operation of interlock monitor switch failure, replace the primary interlock
switch, door sensing switch, monitors witch and power relay.
4 Drive motor is not running properly.
1 remove the dust if any and Replacement of Drive Motor

Parts Explanation Photo Explanation
1 Take out the glass tray,
guide roller from oven cavity,
disconnect power.
2 Remove turn table motor cover
from case bottom.
CAUTION: Remove sharp edge
After cover removal

Drive Motor

3 Disconnect leads from motor.
4 Remove the screws securing
motor to bottom of over cavity.

156
CITS : E & H - Electronics Mechanic - Exercise 162