Page 168 - Electronic Mechanic - TP - Volume - 2

ELECTRONICS MECHANIC - CITS

Following the procedure as shown
in the figure, insert and bend a thin
metal plate between Door“E”and
Removal of Door Door “A” until you hear the ‘tick’
“E” sound.
• Insertion depth of the thin metal
plate should be 0.5mm or less.

Remove pin hinge from Door“E”
Removal of Key Detach spring from Door“E” and
Door & Spring key door.

Replacement of Fuse
1 Disconnect the oven from the power source.
2 When12A fuse blows out by the operation of interlock monitor switch failure, replace the primary interlock
switch, door sensing switch, monitors witch and power relay.

Replacement of Drive Motor

Parts Explanation Photo Explanation
1 Take out the glass tray,
guide roller from oven cavity,
disconnect power.
2 Remove turn table motor cover
from case bottom.
CAUTION: Remove sharp edge
After cover removal

Drive Motor

3 Disconnect leads from motor.
4 Remove the screws securing
motor to bottom of over cavity.

151

CITS : E & H - Electronics Mechanic - Exercise 161