Page 90 - CTS - Dress Making - TP - Volume - 1

DRESS MAKING - CITS

9 There are two basic operating modes in 3D: Navigate. (Default, always
on) & Edit.(CTRL key down). Navigation mode is always “On”, meaning
we can always rotate, zoom & move the mannequin to inspect from
different angles, no changes will occur. Edit mode is available by
holding down the Ctrl key.
10 To move a specific piece, hold Ctrl down, then left click the piece, it
should show a green rectangle indicating its selection. Moving the
mouse left, right up and down moves the piece accordingly. To push
the piece IN and OUT hold Ctrl down, right click it, and then move the
mouse Up and Down.
11 Make sure the pieces are located correctly by inspecting the mannequin
from multiple angles.
12 Using clear cloth tool, remove the fabric from the model.
13 Select ‘Shader’ in the 3D properties dialog box. Select the colour and
texture of the fabric.
14 Use place cloth tool and verify the fabric colour and texture.

15 Remove the fabric using clear cloth tool. Select the Back pattern using selection tool. Select the left half of the
pattern and click Set Half tool.

16 Select stitch tool in 3D tools. Select the front shoulder& Back shoulder, Front side seam & Back side seam,
Front armhole & Sleeve front armhole, Back armhole & Sleeve back armhole and finally sleeve left side seam
& Sleeve right side seam. All the selection should be in Clockwise order only. Notice the change in colour of
the segments after selection.
17 Select the front CF line clockwise using stitch tool. Select Stitch menu in 3D Properties and mark Symmetric.
Note that the flipped has also been marked automatically.

75

CITS : Apparel - Dress Making - Exercise 8 - 29 CITS : Apparel - Dress Making - Exercise 8 - 29