Page 270 - CITS - Fashion Design Technology - Trade Practical
P. 270
FASHION DESIGN & TECHNOLOGY - CITS
TASK 2: Cut and Sew a Basic Shirt.
1 Lay pattern on wrong side of fabric ,transfer marks with chalk and cut all the components
2 Transfer marks of pleats, pockets with tracing wheel on lower layer.
3 Take pattern for collar and cuff and mark on fusing (without seam allowance ) and cut.
4 Prepare half open pocket (Italian placket) and attach it on the left side of front part on mark.
5 Set reverse pleats on back part on mark. Attach yoke and join front and back pieces.(Please refer Skill
Sequence No.1).
6 Prepare one piece placket on sleeves at mark of slit.
7 Attach sleeve on armhole with shirt-sleeve method.
8 Stitch under arm seam and side matching the balance marks.
9 Prepare and attach cuff with sleeve (Please refer the skill sequence No.2)
10 Prepare shirt collar and attach with gorge (neckline) (Please refer the Skill Sequence No.3).
11 Turn the bottom by 0.25 cm first, then take 0.5 cm for Second turn on front and back shirt
12 Turn the bottom by 0.25 cm firt, then take 0.5 cm for second turn on front and back of shirt
13 Overlock all raw seam allowance.
14 Cut and make one-bar-one fan buttonhole in horizontal position on collar (left side). Place it in center of
stand .,1 cm away from edge.
15 Divide the remaining distance of opening into four equal parts and make three vertical one-bar-onr fan button
holes,1 cm away from edge.
16 Stitch buttons accordingly.
17 Stitch button and button hole in the center of each cuff 1 cm away from edge, place them in horizontal direction.
18 Finish and press.
Note : Get the work checked by your Instructor.
255
CITS : Apparel - Fashion Design & Technology - Exercise 21