Page 272 - CITS - Fashion Design Technology - Trade Practical
P. 272

FASHION DESIGN & TECHNOLOGY - CITS





              Fig 5


































           Skill Sequence


           Attach Cuff

           At the end of this exercise you will be able to:
           •  prepare and fix cuff to sleeve bottom.

           Procedure

           1  Place cuff pattern over fusing and cut two pieces. Leaving seam allowance on three sides place fusing piece
              on wrong side of the material.
           2  Turn the longer edge of seam allowance inside. Baste and stitch 0.75 cm away from edge on right side.(Fig 1)
           3  Fold cuff on centre line, right sides together. Baste and stitch from fold side leaving 2 mm unstitched at the
              folded edge and lock the stitch. (Fig 2)

             Fig 1                                             Fig 2











           4  Turn the cuff inside out (take care of corner). Cut notch at centre of raw edge. Press. (Fig 3)

           5  Press  the  placket  inside  and  measure  the  sleeve  bottom. The  difference  between  cuff  length  and  sleeve
              bottom is the measurement for two pleats. Prepare 1st side pleat at side seam. Prepare another side pleat at
              the same distance on the other side placket. (Fig 4)

           6  Baste and stitch underside of cuff (unfused) to wrong side of sleeve bottom matching centre marks. (Fig 5)
           7  Turn the cuff unit up and press seam allowance inside the cuff. Then press the cuff from folded edge.


                                                           257

 CITS : Apparel - Fashion Design & Technology - Exercise 21   CITS : Apparel - Fashion Design & Technology - Exercise 21
   267   268   269   270   271   272   273   274   275   276   277