Page 276 - CITS - Fashion Design Technology - Trade Practical
P. 276

FASHION DESIGN & TECHNOLOGY - CITS


























           Measure 5-7 then less 1/8” from that measurement. Pivot your ruler around on point 20 until it intersects with the

           vertical line 12-22 at the measurement you just found. Mark this meeting point as 23. Connect 20-23.Shape armhole
           9-14 and take extra inside ½” between (13-23) at front armhole.(21-24) & (15-25) = 1¾” for button and buttonhole
           stand.
           Connect 15-25-24-21  .Mark ¼” up from point 24 and shape as shown in draft:
           Yoke Piece: 0-5-7-8-3
           Shirt Back: 3-9-14-18”-17”-1’-1
           Shirt Front: 25-24-21-20-23-13-14-18’-17’-15’-15-25

           Firstcut the draftand mark thisdraft to the fabric with seam allowance of ¼” all around the cutting lines except hemlines.
           Give ¾” seam allowance for hem line. (Hem lines are 1-1’17” & 25-15-15’-17’) cut 1 piece of Front right, front left,
           back and 2 pieces of Yoke.

           Sleeve

























           0-1   = 1/6th armhole circumference
           0-2   = sleeve length (shoulder to wrist)

           1-3   =½ armhole circumference
           Connect 0-3 and divide that line into 3 equal parts then mark that as 0’ & 3’ as shown in draft picture.
           A is 3/8” above from 0’
           B is ¼” below from 3’




                                                           261

                                CITS : Apparel - Fashion Design & Technology - Exercise 22
   271   272   273   274   275   276   277   278   279   280   281