Page 280 - CITS - Fashion Design Technology - Trade Practical
P. 280

FASHION DESIGN & TECHNOLOGY - CITS



           Fold ¼” fold again ½” seam allowances inwards and topstitch pocket mouth.
           Fold ¼” all other 3 sides and press.
           Pocket should be placed 2” away from second buttonhole and 7½” to 8” below from the neckline shoulder corner
           raw edge.Place to pin the pocket at right side of left front piece (refer picture) then sew with edge stitching it
           simultaneously
           Stitching Back Pleat
















           Sew back piece pleats. First Mark  the center at top and mark 1”away from the two sides of center point.
           Make two ½” pleats. As shown in fig above
           Joining  Shirt Front and Back part



































           First place front and back pieces facing right side together.
           Open the yoke pieces like a greeting card. Pin shoulder portion of one of the yoke pieces with Shirt’s front.
           Now start to role from the bottom of front & back pieces together.
           Make a tight role towards the end of yoke attached line.
           Then flip the other yoke piece to the opposite side to join the shoulder area which already pinned. Now the front
           shoulder is in the middle of two yoke pieces shoulder secure with more pins and sew along ¼” away from edges.
           Remove the pins and turn out the shirt front & back through the neckline.
           Press then give top stitch.
              Note: Get the work checked by your Instructor.





                                                           265

 CITS : Apparel - Fashion Design & Technology - Exercise 22   CITS : Apparel - Fashion Design & Technology - Exercise 22
   275   276   277   278   279   280   281   282   283   284   285