Page 299 - CITS - Welder - Trade Practical

WELDER - CITS

Module 8 : Advance welding & cutting

EXERCISE 77(A): Plan & monitor Plasma cutting of

SS sheets plates

Objectives

At the end of this exercise you shall be able to
• mark cutting lines on the plate (job) by keeping proper cutting allowance
• set the job for straight cutting
• clean the edges and inspect for defects Clean and inspect the weld.

Job Sequence

• Begin cutting by placing the torch as close as possible to the edge of the base metal.
• Pull the trigger to ignite the pilot arc.
• Move the torch near the work piece to ignite the cutting arc 4
• Wait for the arc to penetrate through the bottom of the work piece.
• Start moving the torch slowly, perpendicular to the work piece. Watch sparks leaving the bottom of the work
piece to judge your speed. If the sparks are not visible at the bottom of the plate, you have not penetrated the
metal. This is because your travel speed is too fast or you have insufficient output amperage.
• At the end of a cut, angle the torch slightly or pause briefly to completely finish the cut systems.
• Provide a post-flow circuit, the post-flow air will continue for a short period of time after the trigger is releases
to cool the torch and consumable parts. However, cutting can be resumed immediately.
• To maximize cutting speeds, it is recommended to turn your power source to full output for S.S material
thicknesses.
Note: Wear protective clothing.

282