Page 221 - CITS - ED - Mechanical
P. 221

ENGINEERING DRAWING - CITS


                                                       TABLE 3

                                              Symbols for Direction of lay

              SYMBOL                                           INTERPRETATION






                                 Parallel to the plane of projection of the
                                 view in which the symbol is used.







                                 Perpendicular to the plane of projection
                                 of the view in which the symbol is used.








                                 Crossed in two slant directions relative
                                 to the plane of projection of the view
                                 in which the symbol is used.









                                 Multi-directional









                                 Approximately circular relative to the
                                 centre of the surface to which the
                                 symbol is applied.









                                 Approximately radial relative to the centre
                                 of the surface to which the symbol is
                                 applied.





           Note:  It should be necessary to specify a direction of lay not clearly defined by these symbols then this
                 shallbe achieved by a suitable note on the drawing.



                                                           208
                                     CITS :Engineering Drawing (Mechanical) - Exercise 9
   216   217   218   219   220   221   222   223   224   225   226