Page 345 - Electronic Mechanic - TP - Volume - 2

ELECTRONICS MECHANIC - CITS

CI = Connector input, i.e. parameter selects the source of an analog signal

CO = Connector output, i.e. parameter connects as an analog signal

CO/BO = Connector/Binector output, i.e. parameter connects as an analog signal and/or as a binary
signal
To make use of BiCo you will need access to the full parameter list. At this level many new parameter settings are
possible, including BiCo functionality. BiCo functionality is a different, more flexible way of setting and combining
input and output functions. It can be used in most cases in conjunction with the simple, level 2 settings.
The BiCo system allows complex functions to be programmed. Boolean and mathematical relationships can be
set up between inputs (digital, analog, serial etc.) and outputs (inverter current, frequency, analog output, relays,
etc.).

3 CStat
Commissioning status of the parameter.
Three states are possible:
Commissioning C
Run U
Ready to run T

This indicates when the parameter can be changed. One, two or all three states may be specified. If all three
states are specified, this means that it is possible to change this parameter setting in all three inverter states
4 P-Group

Indicates the functional group of the particular.
Parameter P0004 (parameter filter) acts as a filter and focuses access to parameters according to the functional
group selected.
5 Datatype

The data types available are shown in the table below.

Notation Meaning
U16 16-bit unsigned
U32 32-bit unsigned

I16 16-bit integer
I32 32-bit integer
Float Floating point

6 Active
Indicates whether
• Immediately changes to the parameter values take effective immediately after they have been entered, or
• Confirm the “P” button on the operator panel (BOP or AOP) must be pressed before the changes take
effect.
7 Unit
Indicates the unit of measure applicable to the parameter values
8 QuickComm

Indicates whether or not (Yes or No) a parameter can only be changed during quick commissioning, i.e. when
P0010 (parameter groups for commissioning) is set to 1 (quick commissioning).

328
CITS : E & H - Electronics Mechanic - Exercise 227 - 230