Page 347 - Electronic Mechanic - TP - Volume - 2

ELECTRONICS MECHANIC - CITS

Quick commissioning (P0010 = 1)

The following parameters are necessary for quick commissioning (P0010 = 1)

Par.-No. Name Access level Cstat
P0100 Europe / North America 1 C
P0300 Select motor type 2 C
P0304 Motor voltage rating 1 C
P0305 Motor current rating 1 C
P0307 Motor power rating 1 C
P0308 Motor cosPhi rating 1 C
P0309 Motor efficiency rating 1 C
P0310 Motor frequency rating 1 C
P0311 Motor speed rating 1 C
P0320 Motor magnetizing current 3 CT
P0335 Motor cooling 2 CT
P0640 Motor overload factor [%] 2 CUT
P0700 Selection of command source 1 CT
P1000 Selection of frequency setpoint 1 CT
P1080 Min. frequency 1 CUT
P1082 Max. frequency 1 CT
P1120 Ramp-up time 1 CUT
P1121 Ramp-down time 1 CUT
P1135 OFF3 ramp-down time 2 CUT
P1300 Control mode 2 CT
P1910 Select motor data identification 2 CT
P3900 End of quick commissioning 1 C

When P0010 = 1 is chosen, P0003 (user access level) can be used to select the parameters to be accessed. This
parameter also allows selection of a user-defined parameter list for quick commissioning.
At the end of the quick commissioning sequence, set P3900 = 1 to carry out the necessary motor calculations and
clear all other parameters (not included in P0010 = 1) to their default settings.

Note: This applies only in Quick Commissioning mode.

Reset to Factory default
To reset all parameters to the factory default settings; the following parameters should be set as follows:
Set P0010 = 30 Set P0970 = 1

Note: The reset process takes approximately 10 seconds to complete.

330
CITS : E & H - Electronics Mechanic - Exercise 227 - 230