Page 349 - Electronic Mechanic - TP - Volume - 2

ELECTRONICS MECHANIC - CITS

ParNo Parameter name ParNo Parameter name
r0034 CO: Motor temperature (i2t) r1170 CO: Frequency setpoint after RFG
r0036 CO:Inverter overload utilization r1242 CO: Switch-on level of Vdc-max
r0037 CO: Inverter temperature [°C] r1315 CO: Total boost voltage
r0039 CO: Energy consumpt. meter [kWh] r1337 CO: V/f slip frequency
r0067 CO: Act. output current limit r1343 CO: Imax controller freq. output
r0071 CO: Max. output voltage r1344 CO: Imax controller volt. output
r0078 CO: Act. current Isq r1801 CO: Act. pulse frequency
r0084 CO: Act. air gap flux r2015[4] CO: PZD from BOP link (USS)
r0086 CO: Act. active current r2018[4] CO: PZD from COM link (USS)
r0395 CO: Total stator resistance [%] r2050[4] CO: PZD from CB
r0755 CO: Act. ADC after scal. [4000h] r2110[4] CO: Warning number
r0947[8] CO: Last fault code r2224 CO: Act. fixed PID setpoint
r0948[12] CO: Fault time r2250 CO: Output setpoint of PID-MOP
r0949[8] CO: Fault value r2260 CO: PID setpoint after PID-RFG
r1024 CO: Act. fixed frequency r2262 CO: Filtered PID setp. after RFG
r1050 CO: Act. Output freq. of the MOP r2266 CO: PID filtered feedback
r1078 CO: Total frequency setpoint r2272 CO: PID scaled feedback
r1079 CO: Selected frequency setpoint r2273 CO: PID error
r1114 CO: Freq. setp. after dir. ctrl. r2294 CO: Act. PID output
r1119 CO: Freq. setpoint before RFG

Connector/Binector Output Parameters

ParNo Parameter name ParNo Parameter name
r0019 CO/BO: BOP control word r0722 CO/BO: Binary input values
r0052 CO/BO: Act. status word 1 r0747 CO/BO: State of digital outputs
r0053 CO/BO: Act. status word 2 r0751 CO/BO: Status word of ADC
r0054 CO/BO: Act. control word 1 r0785 CO/BO: Status word of DAC
r0055 CO/BO: Act. control word 2 r1204 CO/BO: Status word:Flying start
r0056 CO/BO: Status of motor control r2197 CO/BO: Monitoring word 1

2 Parameter Description
Note: Level 4 Parameters are not visible with BOP or AOP. They are only for service purposes.
Common parameters

r0000 Drive display Min: -
Datatype: U16 Unit: - Def: -
P-Group: ALWAYS Max: -
Displays the user selected output as defined in P0005.
Note:Pressing the “Fn” button for 2 seconds allows the user to view the values of DC link voltage,
output frequency, output voltage, output current, and chosen r0000 setting (defined in P0005).

332
CITS : E & H - Electronics Mechanic - Exercise 227 - 230