Page 380 - Electronic Mechanic - TP - Volume - 2

ELECTRONICS MECHANIC - CITS

You can use the BOP for the following operations:
• Standalone commissioning
• Diagnosis
• Parameter access
• Parameter settings
• SD card operations
• Drive restart
The parameter program steps in V90 drive

Display Example Description Remarks
Save data in drive Refer to "Save parameters in the servo
Save
drive (Page 119)".
Restore drive to default settings Refer to "Reset parameters to default
defu values (Page 119)".

Save data from drive to SD card Refer to "Copy parameters from the
dr--sd servo drive to an SD card (Page 120)".

Upload data from SD card to drive Refer to "Copy parameters from an SD
sd--dr
card to the servo drive (Page 121)".
Update firmware Refer to "Update firmware (Page 122)".
Update

Adjust AI1 offset Refer to "Adjust AI offset (Page 122)".
A OFF1

Adjust AI2 offset Refer to "Adjust AI offset (Page 122)".
A OFF2
The zero position has not been set Refer to "Set zero position (Page 124)".
ABS

The zero position has been set Refer to "Set zero position (Page 124)".
A.B.S.

Actual speed (positive direction)
r xxx

363
CITS : E & H - Electronics Mechanic - Exercise 240