Page 289 - CITS - Fashion Design Technology - Trade Practical
P. 289

FASHION DESIGN & TECHNOLOGY - CITS




           Place short flat on table with wrong side upwards. Turn the seam allowance to shield and right front piece towards
           right front portion. Cover the shield and seam allowance with lining. Baste it. Be careful that the lining is flat on
           shield, so that no folds and wrinkles come in it. (Fig 12)

           Turn the garment to the right side. Stitch close to the left fly seam through all layers. Tack zip flat on waistline on
           both sides 0.5 cm below the waist-line. Trim the edges at the top. (Fig 13)


             Fig 12                                             Fig 13



















           Skill Sequence


           Waist band

           At the end of this exercise, you will be able to
           •  make and fix two-piece waist band with interlining in Pleated Trousers.


           Since waist band has a joint in centre back it consists of 2 outer pieces, 2 inner pieces (lining) and 2 interlining
           (buckram) pieces.
           Place the left waist band piece, over its lining, right sides together. Keep the extended portion to your right hand
           side. Place the interlining on upper side over the seam allowance in opposite direction.
           Baste over the interlining and stitch at a distance of 2 mm form edge. (Fig 1)
           Place and stitch the right waist band piece same as the left but keep extended portion for shield on your left side.
           (Fig 2)

            Fig 1                                          Fig 2


                                                                                                            FDC22P0287




           Turn both waist bands over the interlining, baste it on both sides of waist band pieces. Turn 1.5 cm the raw edge
           of lining towards wrong side and baste it. (Fig 3)
           Pin the top edges of hip pocket down from the waist line. (Fig 4)
           Set waist band on waistline matching balance marks: left waist band with left front and right waist band with right
           front. Pin and baste. (Fig 5)
           Unfold the pocket and baste it to seam line. Trim the edges. (Fig 6)
           Turn the seam allowance on the extended portion of waist band. Press and baste it. (Fig 7)
           Take the six no. of strips for belt carriers. Turn the raw edge of strips 1.5 cm inwards and again turn it towards
           selvedge edge by 1.5 cm. (Note: edge of selvedge should not be visible from outside).



                                                           274

                                CITS : Apparel - Fashion Design & Technology - Exercise 23
   284   285   286   287   288   289   290   291   292   293   294