Page 111 - CITS - Fitter Trade Pactical - Volume - 2
P. 111
FITTER - CITS
Fig 3 Fig 4
Ream the hole through. Ensure that the taper lead length of the reamer comes out well and clear from the bottom
of the work. Do not allow the end of the reamer to strike on the vice.
Remove the reamer with an upward pull until the reamer is clear of the hole. (Fig 5)
Fig 5
Remove the burrs from the bottom of the reamed hole.
Clean the hole. Check the accuracy with the cylindrical pins supplied.
96
CITS : CG & M - Fitter - Exercise 31