Page 303 - CITS - ED - Mechanical
P. 303

ENGINEERING DRAWING - CITS






               Fig 3










           Pline command (Fig 4)
           A polyline is a connected sequence of line segments created as a single object. You can create straight line
           segments, arc segments, or a combination of the two.
           1     Choose  Draw, polyline.
                         (or)

           2     Pick     The pline icon.
           3     Type     PLINE at the command prompt Command: PLINE or PL
           4     Pick     A point on the drawing to start the polyline
                         Form point: (select)

           5     Type     One of the following options Arc/Close/ Half width/Length/Undo/Width/<endpoint of line>:
                          (or)
           6     Pick    A point to continue drawing Arc/Close/ Half width/Length/Undo/Width/<endpoint of line>:
                         (pick point)


            Fig 4







           PLINE options (Fig 5)


              Fig 5





















           Arc : Toggles to arc mode and you receive the following: Angle/CEnter/CLose/Direction/Half width/Line/Radius/
           Second Pt/Undo/Width/<enter of arc>:
           Close : Closes a polyline as it does in the line command.

           Halfwidth : Specifies the half width of the next polyline segments. Can be tapered.


                                                           290
                                  CITS : Engineering Drawing (Mechanical) - Exercise 12
   298   299   300   301   302   303   304   305   306   307   308