Page 304 - CITS - ED - Mechanical
P. 304

ENGINEERING DRAWING - CITS



           Length : Specifies the length to be added to the polyline in the current direction.

           Undo :  Undoes the previous spline segment as with the line command.
           Width : Specifies the width of the next polyline segments. Can be tapered.
           Polyline with arcs
           Polyline with width 125
           Tapered width polyline

           Tapered width arc polyline
           Convert pline to spline (Fig 6)

              Fig 6








           1    Draw     A Pline
           2    Type      PEDIT to edit the polyline as a spline.

           3    Choose  Draw, Spline
           4    Type      Object at the command prompt.
           5    Click     Once on the polyline to turn it into a spline.
           Spline (Fig 7)

           The spline command creates a particular type of spline known as a non uniform rational B-spline (NURBS) curve.
           A NURBS curve produces a smooth curve between control points.

              Fig 7









           1    Choose    Draws, spline.

                          (or)
           2    Click     The spline icon
                          (or)
           3    Type      Spline at the command prompt Command: Spline
           4    Pick      A start point for the spline Object /<Enter first point> (pick point)

           5    Pick      Points until you are done drawing splines Enter point: (pick points)
           6    Press     Enter or close to complete the spline
           7    Pick      Starting tangent point for the spline Enter start tangent (pick point)
           8    Pick      Ending tangent point for the spline

                          Enter end tangent (pick point)







                                                           291
                                    CITS : Engineering Drawing (Mechanical) - Exercise 12
   299   300   301   302   303   304   305   306   307   308   309